|
|
TGT-K62-1-DH38
|
| 1 | Retractor |
| 1 | Solenoid Valve |
| 1 | Pressure Gauge |
| 1 | Manual Shutoff Valve |
| 1 | 12' x 3/8" Hose Assembly, AGA Certified 1-93 (electrically conductive CNG twin hose) |
| 1 | Micro Motion DH38 Mass Flow Meter (rated at 5000psi, 50 lbs./minute, 1000 cfm) |
| 1 | Price Change Communicator |
| 1 | Concrete Island Form |
| 1 | ASME Relief Valve |
| Powder Coated Steel Chassis w/ Stainless Steel Trim |
Optional: |
|
Parker Finite J2SD Filter Installed in Dispenser Dispenser Base Shear Breakaway System Installed in Dispenser Temperature Compensation from the Dispenser NGV1 Type 2 Refueling Connector (Staubli) NGV1 Type 1 Refueling Nozzle (Sherex CT1000) Three Bank Valve Panel One Hose, Model TGT-VP3B1D Pressure Regulator used when dual pressure and elevated storage Upgrade to ½" Hose High Flow Rate Nozzles call for quote Custom screen printed face plates |
|
Also Available:
Weights and Measures Certification is required when you are transferring custody of fuel to another party. The Weights and Measures Field Inspector requires some additional hardware to allow them to do a field evaluation of the calibration of the dispenser: (1) have a switch that will allow the inspector to change the GGE volume display into a Mass volume display; (2) connect the Rosemount 275 Hand Held Programmer and access the Audit Trail inside the Micro Motion Transmitter; (3) manufacturer to recalibrate the dispenser and seal all enclosures; and (4) maintain a database on meter calibration and location of dispenser. Contact us for pricing information |
Requires Acrobat Reader Technical and Installation Info |
At Work    
|
Tulsa Gas Technologies 4809 S. 101st E. Ave. Tulsa, OK 74146 (918) 665-2641 
|
This dispenser is a one-line
dispenser that independently meters the gas and gives you a display on both sides of the dispenser. The dispenser has two 4-20ma output that can send flow or temperature to a controller. The dispenser has a dry contact and a 120v hook switch for an "in use" signal and will send pulses to a card reader or a console. The Micro Motion Transmitter is located within the dispenser body and is factory set and calibrated before shipment. TGT assembles an AGA 1-93 approved Parker Paraflex CNG fill hose on all its dispensers. The breakaway is the Snap-tite Inline type with a unique vent breakaway attached to the fill hose breakaway. All 1999 and later CNG Dispensers have an ASME pressure relief valve inside the dispenser cabinet with a vent stack up through the retractor pole. The cabinet is constructed of 11 gauge cold roll steel with a powder coat finish then a high quality mirror stainless steel trim is attached to the outside of the cabinet which will give you years of new appearing equipment. As an option, this dispenser can temperature compensate the fill pressure of the gas and do electronic sequencing of the gas from the storage to the dispenser.